ArtCAM MillWizard 1.3 Evaluation Version (700KB)

In order to download the Evaluation Version of ArtCAM MillWizard, please fill in the fields below and supply a valid email address so that we can email an activation password to you. Without this password the ArtCAM MillWizard Evaluation will not run.

Click the above link to download the latest Evaluation Version. If you have an older evaluation version you can simply install this over it. The Evaluation Version will generate toolpaths, but only for the four sample files listed below. One of these files is included with the ArtCAM MillWizard Evaluation Version so you can get started straight away.

You can also use the Evaluation Version to load your own models and generate and simulate the toolpaths for them, but you can only save these toolpaths in the ArtCAM MillWizard Full Version which can be purchased from here.

Installing
The ArtCAM MillWizard Evaluation version comes in a self-contained installation file, installmw.exe. Once you have saved this to disk, run it to install ArtCAM MillWizard. When you run ArtCAM MillWizard for the first time you will be asked to enter a password which will be supplied to you via email when you download.

Evaluation models
These are self extracting zip files, run them after downloading and they will unzip the files to the default ArtCAM MillWizard example directory. There are some new files here that work with evaluation version 1.3 (available above). But not with version 1.2

• nefertiti.exe (12Kb) - A 3DS file. This is supplied with the Evaluation Version
• knight.exe (151Kb) - A 3DS file.
• lady.exe (964Kb) - An STL file.
• dolphin.exe (204Kb) - A 3DS file.
• NEW! Dino.exe (1.2Mb) - An STL file.
• NEW! Butterfly.exe (913Kb) - An STL file.
• NEW! MtSTHelens.exe (1.39Mb) - An STL file.